AIRTRONICS MT-4s Guía de usuario descargar pdf (Pagina 59)

T R



Changing the Trim Type:

1) From within the SYSTEM menu, scroll UP or DOWN to highlight the TRIM TYPE menu.

SYSTEM











The Trim Type function allows you choose the way servo Trim and servo End Point Adjustments interact with each other. When

you apply Trim to a servo, the Neutral Point of the servo shifts toward the High Side or the Low Side. When you do this, the servo

travels less in one direction and more in the other direction because the servo End Points are stationary. In order to balance the

servo travel, you would need to manually readjust the servo End Points. Using the Trim Type function allows you to make the

servo End Points shift toward the High Side or the Low Side when you apply Trim. This maintains balanced servo travel without

the need to manually readjust the servo End Points.

The Trim Type function does not effect servo Sub-Trim. It only effects servo Trim that's input using the Trim Switches, Rotary

Dial or Auxiliary Lever. Servo Sub-Trim, which is different, always uses Parallel Trim.

Two Trim Types are available:

CENTER - When Selected, servo End Points are stationary. In order to balance servo travel, you would need to

manually readjust the servo End Points, if desired.

PARALLEL - When Selected, servo End Points shift toward the High Side or the Low Side automatically

when you apply Trim. This maintains balanced servo travel without the need to manually readjust the

servo End Points.

2) Press the ENTER key. The TRIM TYPE menu will be displayed and [ST] CENT will be

highlighted.

3) Scroll UP or DOWN to highlight the desired channel you would like to change the Trim

Type option for. Choose from either [ST] CENT (Steering), [TH] CENT (Throttle), [AUX1]

CENT (Auxiliary 1) or [AUX2] CENT (Auxiliary 2).

4) Press the ENTER key, then scroll UP or DOWN to choose the desired Trim Type option

for that channel.

TRIM TYPE setting range is CENT and PARA. The default setting for all channels is CENT.

The Auxiliary Type function allows you choose which Auxiliary function is assigned to Auxiliary 1 Channel 3 or Auxiliary 2

Channel 4. One Auxiliary function can be assigned to each Auxiliary Channel and both Auxiliary Channels can be Active and

controlled at the same time using different controls. For example, you can control Auxiliary 1 Channel 3 using the Rotary Dial

and Auxiliary 2 Channel 4 using the Auxiliary Lever.

For details about programming and using each of the Auxiliary functions, in addition

to selecting AUX Type Modes, see the Auxiliary 1 Programming section on pages 27

through 33 or the Auxiliary 2 Programming section on pages 34 through 40.











Changing the Auxiliary Function:

1) From within the SYSTEM menu, scroll UP or DOWN to highlight the AUX TYPE menu.

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 87 88

Comentarios a estos manuales

Sin comentarios

AIRTRONICS MT-4s Guía de usuario Pagina 59

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos AIRTRONICS MT-4s