AIRTRONICS MX-V Especificaciones descargar pdf (Pagina 8)

Page 8





1) Remove the battery cover on the bottom of the transmitter by pushing rmly on the battery cover in the direction

of the arrow.

2) Install eight fresh 'AA' Alkaline batteries into the battery tray, making sure that the polarity is correct. The direction

that each battery should be installed is molded into the battery tray (+ Positive and - Negative).

3) Slide the battery cover back onto the transmitter and push it rmly until it 'clicks' closed.

If you prefer to use rechargeable Ni-Cd or Ni-MH transmitter batteries, please see the options on the

next page.



Use the diagram below to familiarize yourself with how to connect the switch harness, servos (available separately),

and the 4 cell battery holder to your 92524 3-Channel receiver.

1) Install four fresh 'AA' Alkaline batteries into the battery holder, making sure that the polarity is correct. The direction

that each battery should be installed is molded into the battery holder (+ Positive and - Negative).

We suggest Binding the transmitter and receiver and setting the Throttle Fail Safe position, prior to mounting the

receiver in your model.

The receiver should be mounted as far away from any electrical components as possible.

Route the antenna wire up through a plastic tube so that it is in the vertical position.

To protect the receiver from vibration and other damage, we recommend wrapping the

receiver in shock absorbing foam rubber when installing it in your model.

Set your model on a stand so the wheels are off the ground before turning on your

radio control system or connecting your motor for the rst time.

Steering

Servo CH1

Throttle

Servo CH2

Auxiliary

Servo CH3

Switch

Receiver

The 92524 3-Channel receiver's Nominal Input Voltage is 4.8v~6.0v, therefore, the receiver can be powered

using a 4 or 5 cell Ni-Cd or Ni-MH battery pack (available separately).

The receiver does not feature BEC circuitry. If using an electronic speed control, verify

that it features BEC circuitry to drop the receiver voltage between 4.8v~6.0v.

AA Dry Cell Battery Holder

or 4 to 5 cell Ni-Cd or Ni-MH

Switch

To Battery

To Motor

ESC

Throttle

CH2

Batt

Antenna Tube

Antenna Wire













Steering

CH1

Auxiliary

CH3

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comentarios a estos manuales

Sin comentarios

AIRTRONICS MX-V Especificaciones Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos AIRTRONICS MX-V

Powiązane produkty i podręczniki dla Grzejniki Danfoss AVT (Generation 2006)