AIRTRONICS MX-V Especificaciones descargar pdf (Pagina 3)

Page 3

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed

and used in accordance with the operating instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced technician for help.

This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to

the following two conditions:

1) This device may not cause harmful interference, and....

2) This device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modications made to this equipment not expressly approved by Airtronics may void the

FCC authorization to operate this equipment.

RF Exposure Statement

This transmitter has been tested and meets the FCC RF exposure guidelines when used with the Airtronics accessories

supplied or designated for this product, and provided at least 20cm separation between the antenna and the user's

body is maintained. Use of other accessories may not ensure compliance with FCC RF exposure guidelines.



This is a high-output full-range radio control system that should well exceed the range needed for any surface model.

For safety, the user should perform a range test at the area of operation to ensure that the radio control system has

complete control of the model at the farthest reaches of the operational area. Rather than operating the model, we

recommend that the user enlist the help of a fellow modeler to walk the model to the farthest reaches of the track (or

for boats, to walk the shore line well in excess of the operational distance of the boat), then test for proper operation.

'Safety First' for yourself, for others, and for your

equipment. Your model can cause serious damage or

injury, so please use caution and courtesy at all times.

Observe all the rules of the eld, track, or lake where

you operate your radio control equipment.

If at any time during the operation of your model,

should you feel or observe erratic operation or

abnormality, end your operation as quickly and safely

as possible. DO NOT operate your model again until

you are certain the problem has been corrected.

TAKE NO CHANCES.

Please waterproof the receiver and servos by placing

them in a water-tight radio box when operating R/C

model boats.

If you have little to no experience operating R/C

models, we recommend you seek the assistance of

experienced modelers or your local hobby shop for

guidance.

The Low Voltage Alarm will sound when the transmitter

battery voltage drops to 8.5 volts. If this occurs, stop

using the transmitter as soon as possible, then

replace or recharge the transmitter batteries.





The 2.4GHz frequency band may be used by other devices, or other devices in the immediate area may cause

interference on the same frequency band. Always before use, conduct a bench test to ensure that the servos

operate properly. Also, conduct checks with the transmitter as distant as possible from your model.

The response speed of the receiver can be affected if used where multiple 2.4GHz radio controllers are being

used, therefore, carefully check the area before use. Also, if response seems slow during use, stop your model

immediately and discontinue use.



Continued on Next Page

1 2 3 4 5 6 7 8 ... 23 24

Comentarios a estos manuales

Sin comentarios

AIRTRONICS MX-V Especificaciones Pagina 3

Comentarios a estos manuales

Relacionado con productos y manuales para Controles remotos AIRTRONICS MX-V