Page 11
The Binding function allows you to Bind the transmitter and receiver pair. When new, it is necessary to pair the
transmitter and receiver to prevent interference from radio controllers operated by other users. This operation is
referred to as 'binding'. Once the binding process is complete, the setting is remembered even when the transmitter
and receiver are turned OFF. Therefore, this procedure usually only needs to be done once.
Before beginning the binding process, connect the switch harness, servos, and the receiver battery to your
92524 3-Channel receiver, using the diagram on page 8. Make sure that both the transmitter and the receiver
are turned OFF.
1) Turn the transmitter ON. The Power Indicator on the transmitter will illuminate solid blue.
Under some circumstances, the receiver may not operate after turning the transmitter and receiver ON. If this
occurs, perform the binding process again.
When the binding process is successful, the Bind LED on the receiver will stay solid blue when both the
transmitter and receiver are turned ON. If the Bind LED on the receiver is ashing rapidly or not illuminated
at all, the transmitter and receiver are not paired. In this case, turn both the transmitter and receiver OFF, then
repeat the binding process.
2) While holding down the Bind Button on the receiver, turn the receiver ON.
The Bind LED on the receiver will ash slowly. After ~2 seconds release
the Bind Button. The Bind LED on the receiver will continue to ash slowly.
3) Quickly press the Bind Button on the back of the transmitter. The Bind
LED on the receiver will ash rapidly for ~3 seconds, go out momentarily,
then illuminate solid blue, indicating the binding process is complete.
The Throttle Fail Safe function automatically sets the throttle servo to a predetermined position in the event that the
signal between the transmitter and the receiver is interrupted, whether due to signal degradation or to low transmitter
battery voltage. For example, the Throttle Fail Safe function can be set so that the throttle returns to idle or the
brake engages so that your model doesn't run away if the signal is lost.
Setting the Throttle Fail Safe Position
1) Turn the transmitter ON, then turn the receiver ON. Move the transmitter steering wheel and throttle trigger to
verify correct servo movement.
2) Move the throttle trigger to the desired Throttle Fail Safe position. While holding the throttle trigger in the
desired position, press and HOLD the Bind Button on the receiver. After ~2 seconds, the Bind LED will begin
to ash slowly. Continue holding the Bind Button until the Bind LED begins to ash rapidly (~2 more seconds).
Once the Bind LED begins to ash rapidly, release the Bind Button.
3) Turn the transmitter OFF to test the Throttle Fail Safe operation. The throttle servo should move to the position
that you set in step 2.
Clearing the Throttle Fail Safe Setting
1) To clear the currently programmed Throttle Fail Safe settings, re-bind the transmitter and receiver pair.
The Throttle Fail Safe function will not operate if the receiver loses power, for example, if the receiver battery
comes loose or if the receiver battery is drained.
(2 paginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales